• Use for removing diesel fuel pipe connector. • Applicable for FUSO 4P10 EURO 5 engine. • FUSO NO.: MH064211.

The oil filter wrench 36 mm is specially designed for removing the oil filter. Used with 1/2″ Dr. tool or 21 mm wrench. Spec: 6P / 36 mm. ... more info

The oil filter wrench 32 mm is specially designed for removing the oil filter. Used with 1/2″ Dr. tool or 21 mm wrench. Spec: 6P / 32 mm. ... more info

The Benz serpentine belt tool is specially designed to turn the idler and replace the serpentine belt easily. Size: T55 x 500 mm (Length). ... more info

• Use for holding flywheel to prevent from rotating. • Applicable for FUSO 4P10 EURO 5 lift cars/ IVECO engine (SAT). ... more info

• Use for holding flywheel to prevent from rotating. • Applicable for FUSO 4P10 EURO 5 lift cars/IVECO engine. (MANUAL) ... more info

The diesel oil filter wrench for Canter is used to remove the oil filter and drain fuel from the filter. Size: 1/2″ Dr. x 50 mm / 6 PT. ... more info

The VAG dual-charging engine idle wheel wrench has a special angle with 16 mm open end design for rotating the idle wheel to replace the belt easily. ... more info

Feeler gauge length: 89 mm (3.5 inches). Width: 12.8 mm. Metric sizes: 0.127, 0.157, 0.178, 0.203, 0.229, 0.254, 0.279, 0.305, 0.330, 0.356, 0.381, ... more info

The bended feeler gauge has 12 blades in total. Length: 89 mm. Width: 12.8 mm. Metric sizes: 0.203, 0.254, 0.305, 0.330, 0.356, 0.381, 0.406, 0.457, ... more info