The tool is used with JTC-6770, JTC-4091, JTC-4831, JTC-4704, JTC-4820, JTC-4373, JTC-4375, JTC-6975. Application: non-shaft assembly objects. Size: ... more info

The BMW Mini camshaft drive chain is specially designed to check the timing chain stretch on BMW Mini petrol engines without dismantling the engine. ... more info

The BMW Mini crankshaft rotating and holding tool is specially designed to rotate the crankshaft and fix the flywheel. Application: BMW Series: 1, 2, ... more info

The Ford crankshaft front oil seal is specially designed for installing the crankshaft front oil seal without damage. The tool is capable to locate ... more info

The Ford crankshaft pulley is specially designed to remove and install the crankshaft pulley, in order to replace the timing belt. Application: Ford ... more info

Specially designed to install the nylon bushing into the shift shaft. Application: Benz W124, W126, W140, W201, W210, etc; Ford, BMW, VW, Audi (with ... more info

The BMW B38 front crankshaft oil seal is specially designed to protect and install the front crankshaft oil seal to the correct position. ... more info

Special designed to pull out the 4, 5, 6 hole front hub easily with outsize hammer. Increasing the power of pulling with both hands held outsize ... more info

The hub puller with enlarged plate is designed to remove the hub rear axle. Used for removing and installing by screw force. P.C.D range from 120 ... more info

The Mazda diesel oil filter wrench is used to remove the oil filter and drain fuel from the filter. Size: 1/2″ Dr. x 85.5 mm / 15 PT x 95 mm ... more info