The Subaru ball joint remover is specially designed for removing the front suspension ball joints for Subaru, Saab vehicles without damaging the ... more info

The rear trailing arm bush installer and remover is used for dismounting and mounting of the rear axle beam bush. Used on car operation, so no need ... more info

The exhaust gas recirculation remover kit is used to disassemble the exhaust gas recirculation (EGR) valve without damaging the parts. Application: ... more info

The Suzuki belt tension adjuster is specially designed to turn the belt angle and fix the tension. Applicable: Suzuki MH35S, MH55S. SM number: ... more info

The multi-direction hose clamp pliers are used for VW and Audi fuel lines, tank ventilation line clamps, and for general radiator hose clamps. ... more info

The VAG fuel tank lid remover is specially designed for removing the fuel tank lid on diesel and petrol vehicles. Applicable: VW, Audi, Skoda, Seat. ... more info

The VAG camshaft pulley holder tool set is used to adjust and fix the angle of the camshaft. Applicable: VAG 3-cyl. 4-cyl. (1.0L, 1.2L, 1.4L EA211 ... more info

The JLR balance shaft timing tool set is used to rotate and adjust the balance shaft. Designed for DOHC 2.2 diesel engines. Application: Ford, Land ... more info

The Benz inner chain check valve installer is specially designed to install the inner chain check valve. Application Benz M276 engine. MM number: ... more info

The VAG crankshaft rotator is specially designed to turn the crankshaft over and into position for alignment purposes. Application: VAG 2.7 / 3.0 TDi ... more info